The
bike cargo trailer build us almost done. I still need to add a floor of
some kind. The thing is huge!! Probably too big. The 1-inch square
alimony tube lengths were 96 inches long, so I just cut those in half.
I
can make the trailer narrower later if needed (probably will). I
used the WIKE bike cargo trailer kit to build it. The trailer measure 51
inches by 48 inches and is rated to carry up to 125 lbs. I might also
just order another kit and build a second smaller trailer. I can then
use both trailers according to need.
The
idea is to use this gizmo to haul my large heavy 35x35 plates to the
camera from the darkroom trailer. I would also like to use it to haul my
20x24 camera and tripod to farther off shooting locations. I hope I do
not over burden my electric bike.
It
all sounds a bit lazy, but I am trying to figure ways to reduce the
workload for the project as I age. I might be making 20 35x35 inch glass
Ambrotype plates a day to get, 1 or 2 good ones. 20 plates works out to
carrying the heavy, loaded, super holders 40 times. When I am 65 plus
that might be a tall order!
Note* I think the super large cart needs to remain the size it is now. The 35x35 holder and its frame holder only allows for about 6 extra inches of room. Meaning I will have about 3 inches on each side of the holder when it is placed flat in the trailer, not a lot! The trailer actually needs to be that big!
No comments:
Post a Comment